![]() For cabinet pulls, standard center-to-center screw holes measure between 3 to 5 inches, or 64, 96, and 128 millimeters apart. Drill + small drill bit (if drilling custom holes)Ĭenter-to-center: This measures the space between the two screw holes used to install each side of a drawer pull, which could be slightly wider or narrower than the total length of your drawer pull.See our list of essentials and key measurements below so you have all the information you need before starting. ![]() ![]() If you're drilling the holes yourself, there's a bit more information involved to ensure you get it right the first time. If you're ordering new cabinetry for your kitchen or bath, you'll want check the measurements for any pre-drilled holes so they align with your hardware size. Before purchasing, make sure you check the mounting type and center-to-center size of your existing hardware or pre-drilled holes. Our cabinet hardware comes equipped with all the necessary screws and mounting hardware, making installation easy. Switching your cabinet hardware takes only minutes for each cabinet-all you need is a measuring tape, standard screwdriver, and your new hardware. Swap out your existing kitchen hardware for a quick refresh, or complete your new bathroom vanity with a set of drawer pulls. Installing new hardware provides the perfect finishing touch for your space, whether you're planning a full kitchen remodel or doing a DIY cabinet update.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |